Poured Wire Rope Socket Assemblies
Wire Rope assemblies with fittings permenantly attached at ends are custom fabricated for use as boom pendants, guylines, raising lines, backstays, lifting spreaders, etc. These are offered in both poured, or spelter, sockets and mechanically swaged sockets. A Design Factor of five is
applied in establishing Rated Capacities shown.
-
-
EPOXY COMPOUND SPELTER SOCKET
Epoxy compound is standard as the bonding medium
surrounding wires inside the socket. Steel forgings are
used for rope sizes 1/2” through 1-1/2” and cast steel
fittings for larger sizes. Larger than 4” available on special
order. Assembly length is measured from centerline of pin
for open sockets and bearing point for closed sockets.
*All poured socket assemblies are proof tested upon completion and
certificates will accompany finished products.
|
Rated Capacity shown apply only to 6x19 and
6x37 EIP IWRC class wire rope.
|
Mobile Load Testing Services and Inspections
We offer inspections and mobile proof test services for product verification, break testing, and load testing to ensure compliance for all wire rope slings we sell and repair. Our mobile proof test services are available throughout the United States. In addition to our mobile load testing services we have stationary test beds to service Oklahoma, Texas, Kansas, Wyoming, North Dakota, New Mexico and all surrounding areas.
