Triple Leg Wire Rope Slings - 6x19 & 6x37 Bright EIPS IWRC
Triple leg wire rope slings commonly have a mechanical splice / flemish eyes on the end of the body, and are constructed of 3 wire rope assemblies that are attached to an oblong master link. The lifting ends of the wire rope legs can be fitted with a variety of hooks, eyes, or rings to allow attachment to any object. These are designed to lift unbalanced loads. Wire rope slings are constructed of strong high quality steel that is resistant to corrosion, heat, sunlight, and most chemicals. Thimbles greatly improve sling longevity by protecting the wire rope at connection points. Our wire rope slings are custom built to meet your specific needs for any application.
-
*
-
 |
*Larger sizes available upon request.
Rated Capacities Backet Hitch based on D/d ratio of 25.
Rated Capacities based on pin diameter no larger than natural eye width or less than nominal sling diameter.
Rated Capacities based on design factor of 5.
Horizontal Sling angles less than 30 degrees shall not be used.
Rated Capacities shown apply only to 6x19 and 6x37 classification wire rope. - EIPS IWRC Rated Capacity in Tons.
|
Mobile Load Testing Services and Inspections
We offer inspections and mobile proof test services for product verification, break testing, and load testing to ensure compliance for all wire rope slings we sell and repair. Our mobile proof test services are available throughout the United States. In addition to our mobile load testing services we have stationary test beds to service Oklahoma, Texas, Kansas, Wyoming, North Dakota, New Mexico and all surrounding areas.
